File service › Guides › OBD, bench or boot reading: which one to choose?
Guides

OBD, bench or boot reading: which one to choose?

OBD, bench or boot: the three ways to read an ECU before tuning, their pros and cons, and what to send to the file service.

Three ways to read an ECU

Before changing a calibration, you need a complete copy of the ECU. Depending on the ECU and your tool, this read is done through the vehicle's OBD port, on the bench (ECU removed and connected by its pins) or in boot mode (direct access to the processor, ECU opened).

OBD reading

The simplest: nothing to remove. It works for many recent or unprotected ECUs. However, some ECUs only give part of their memory over OBD, or can no longer be read this way at all.

Bench reading

The ECU is removed and powered on the bench. The read is often more complete (internal memory, EEPROM) and works on ECUs that are protected over OBD. It takes more time and care.

Boot reading

The ECU is opened to access the processor directly. It is the last resort for the most protected ECUs: it gives the most complete copy, but requires equipment and experience.

What to send to the file service

Always send the complete read exactly as your tool saved it, unmodified, and state the reading mode (OBD, bench or boot), the tool and the vehicle. Keep the original read safe: it is your backup to go back to stock.

See also

Ready to send your read?

Open your account in one minute: professionals and enthusiasts with a reading tool.

Open my account →